Camp Wounded Dog ~~Coleman type arc lamp FrankenArc= Ready

Just a little something I threw together out of spare parts I had laying around the shop–think it is from a nautical warning Bouy ~~~ Camp Wounded Dog

Build Your Own Copper Coil Alcohol Burner Stove!

Shop on Amazon via this link and help support the channel!: https://www.amazon.com/shop/iridium242 Stock up on your long term food storage here! https://www.thrivelife.com/iridium242
Channel: Iridium242
Published: 2016-09-08 22:41:00
Duration: 16M24S
Views: 1438717
Likes: 18363
Favorites: 0

How to refill a one pound propane bottle

Channel: JIUJITSU2000
Published: 2013-06-06 17:05:26
Duration: 12M31S
Views: 743092
Likes: 8727
Favorites: 0

How I Light a Coleman Lantern

PRESSURIZED GAS LANTERNS CAN BE EXTREMELY DANGEROUS AND HAVE INJURED AND KILLED MANY PEOPLE! LIGHT AND USE AT YOUR OWN RISK!

Tips:
-If the lantern starts to flicker/dim, try turning the cleaning lever several times. If that doesn’t do anything the pressure is low and it is time to pump again.
-If the lantern hasn’t been lit for a while, it may take a minute for the fuel to reach the mantles, so if it doesn’t light right away don’t automatically assume there is a problem.

Instructions for lighting, as stated on the Model 228H lantern from the video:
“TO FILL
1. Close pump knob and fuel valve firmly. Fill in level position. DO NOT TIP.
2. Replace fuel cap. Tighten firmly.

TO PUMP
3. Test pump. Close pump knob firmly, place thumb over hole in pump knob and pump. If you feel little or no resistance, oil or replace pump leather.
4. Open pump knob one complete turn left. Cover hole in knob with thumb and pump 35 strokes. Close knob firmly.

TO LIGHT
5. Turn cleaning lever down.
6. Hold lit match near mantles. OPEN VALVE WHEEL 1/4 TURN ONLY. Mantles will take a few seconds to light.
7. When mantles glow brightly (no flame) open valve wheel full left.
8. Add pressure. Keep good pressure in lantern. DO NOT adjust light output. NOTE: Flames other than at mantles indicate flooding. Close valve wheel firmly. Permit flame to burn out. Allow lantern to cool. Review instructions.

TO TURN OFF: Rotate cleaning lever several times. Leave in down position. Close valve wheel firmly.”

Facebook: https://www.facebook.com/WeekendHandymen-420780474617450

Channel: WeekendHandymen
Published: 2012-05-14 05:55:18
Duration: 8M5S
Views: 210035
Likes: 530
Favorites: 0

Leave a Reply

Your email address will not be published. Required fields are marked *